DAEWOO ELECTRONICS KOR-63D79S User Manual download pdf (Page 3)

2

This appliance must be earthed. In the event

of an electrical short circuit, earthing

reduces the risk of electric shock by

providing an escape wire for the electric

current. This appliance is equipped with a

cord having a earthing wire with a earthing

plug. The plug must be plugged into an

outlet that is properly installed and earthed.

WARNING

Improper use of the earthing plug can result

in a risk of electric shock.

Consult a qualified electrician or serviceman

if the earthing instructions are not

completely understood, or if doubt exists as

to whether the appliance is properly earthed.

If it is neceswsary to use an extension cord,

use only a 3-wire extension cord that has a

3-blade earthing plug, and a 3-slot

receptacle that will accept the plug on the

appliance. The marked rating of the

extension cord should be equal to or greater

than the electrical rating of the appliance.

1. Steady, flat location

This oven should be set on a steady, flat

surface. This oven is designed for counter

top use only.

2. Leave space behind and side

All air vents should be kept a clearance.

If all vents are covered during operation,

the oven may overheat and, eventually,

oven failure.

3. Away from radio and TV sets

Poor television reception and radio interference

may result if the oven is located close to a TV,

Radio antenna, feeder and so on.

Position the oven as far from them as possible.

4. Away from heating appliance and

water taps

Keep the oven away from hot air, steam or

splash when choosing a place to position it,

or the insulation might be adversely

affected and breakdowns occur.

5. Power supply

•

Check your local power source. This oven

requires a current of approximately 15

amperes, 220V~240V 50Hz.

•

Power supply cord is about 0.8 meters long.

• The voltage used must be the same as

specified on this oven. Using a higher

voltage may result in a fire or other

accident causing oven damage. Using

low voltage will cause slow cooking.

We are not responsible for damage resulting

from use of this oven with a voltage of

ampere fuse other than those specified.

• If the supply cord is damaged. It must

be replaced by the manufacturer or its

service agent or similarly qualified

person in order to avoid a hazard.

6. Examine the oven after unpacking for

any damage such as:

A misaligned door, Broken door, A dent in

cavity. If any of the above are visible, DO NOT

INSTALL, and notify dealer immediately.

7. Do not operate the oven if it is colder

than room termperature.

(This may occur during delivery in cold

weather.) Allow the oven to become

room temperature before operating.

8. The minimum height of free space

necessary above the top surface of the

oven is 100mm.

EARTHING

INSTUCTIONS

INSTALLATION

SAVE THESE INSTRUCTIONS

1 2 3 4 5 6 7 8 ... 11 12

Comments to this Manuals

No comments